This study reports the development of a new Ti-Zr-Mn-based AB₂ type hydrogen storage alloys for a two-stage metal hydride hydrogen compressor (MHHC). The hydrogen storage alloys are designed to compress hydrogen from 35 to 865 bar within a temperature difference of 115 °C. High-pressure PCT measurements up to 700 bar were carried out to test the performance of the alloys. The alloys' hysteresis and the plateau slope were reduced by optimizing the composition. The introduction of fugacity correction into the Van't hoff equation reduces the deviation between calculation and actual pressure to 24 bar at a pressure above 350 bar. A precise relation between the Ti/Zr ratio and the desorption pressure is described and helps make a correct design of the alloy composition. The designed alloy shows looses less than 1% of the capacity over 3000 full cycles. The desorption plateau pressure of the alloy is constant within 92% during the whole cycling process. A 2 stages compressor working with two types of alloys offers compression with a temperature range between -20 and 95 °C for the refueling hydrogen vehicles up to 865 bar.